The Original CZ Forum
GENERAL => CZ Gunsmithing => Topic started by: newtocz on December 04, 2017, 04:22:50 PM
-
Do you guys install a new cross pin when you replace a front sight?
I have 75 B SA.
-
Yes, the pins are cheap. If you don't have a pin, you can reuse the old one, but it may look a little dinged up.
Cheers,
SG
-
not mandatory, specially if you have a good roll pin punch. O0
-
I forgot to order pins hence the question. I'll order some with my next big order just do not want to pay for shipping only for pins.
@copemech do you use brass roll pin punches, or steel is alright?
-
Steel~!
-
Never have
-
Thanks, guys.
-
Pretty much every time.......on rare occasions the original can be reused, in my experience
-
Where do you buy roll pins?
I see CZ Custom has one for 75 front sight, I also need some pins for P-10C.
-
Right, CGW also has front sight pin. What about pins of other sizes, e.g. back strap pin for P-10C.
-
Found Brownells has a bunch of different sizes just need to find out which one I need.
-
Do you guys know the size of the front sight pin by any chance so I do not have to remove it?