Author Topic: Will Any Other Magazines Fit the CZ 100/101/110  (Read 3988 times)

0 Members and 1 Guest are viewing this topic.

Offline Radom

  • Hero Member
  • *****
  • Posts: 2588
  • HGWT
Will Any Other Magazines Fit the CZ 100/101/110
« on: March 01, 2003, 11:55:15 PM »
Dear Owners:

The info that CZF members have provided on these pistols is still fairly minimal.  I am compiling the FAQ on CZ Magazine Compatability, and I would greatly appreciate your help.

1.  Will the magazines for the 75/85 series pistols fit and function in the CZ 100 series pistols?  I have had two answers so far: one "yes" and one "no."

2.  The CZ 100 and 110 take the same magazines.  Will the OEM magazines for the CZ 100 and 110 fit the CZ 101?  I assume that they stick out quite a bit, if they will fit in the grip.  

3.  Do you know of any aftermarket magazines for the CZ 100 series pistols?  

Thanks for your help.

The artist formerly known as FEG...

Offline Old Coastie

  • Hero Member
  • *****
  • Posts: 800
Will Any Other Magazines Fit the CZ 100/101/110
« Reply #1 on: March 05, 2003, 05:34:12 PM »
FEG,

I'll answer what I can with my limited knowledge.

[1. Will the magazines for the 75/85 series pistols fit and function in the CZ 100 series pistols? I have had two answers so far: one "yes" and one "no."] I know the magazines from my Jericho 941 (Pre-ban model) will fit in my CZ100's but extend beyond the bottom of the grip about 1". Once inserted they will operate the slide stop. I do not know how well they operate under actual firing conditions, as I haven't tried them.

[2. The CZ 100 and 110 take the same magazines. Will the OEM magazines for the CZ 100 and 110 fit the CZ 101? I assume that they stick out quite a bit, if they will fit in the grip.] No information as I don't know what a CZ 101 is.

[3. Do you know of any aftermarket magazines for the CZ 100 series pistols? ] Pro Mag makes both 9mm and 40 S
Just because you're paranoid, it doesn't mean they're not really after you!

Offline Radom

  • Hero Member
  • *****
  • Posts: 2588
  • HGWT
Will Any Other Magazines Fit the CZ 100/101/110
« Reply #2 on: March 05, 2003, 06:18:27 PM »
The CZ 101 is a compact version of the CZ 100.  It has a single-stack magazine, but the grip seems to be the same width.  I'm not sure.  It holds 7 rounds in the 9mm version and 6 in .40 S&W.    

This model was not imported by CZ-USA, but it used to be listed at the CZ-UB (European) website.  It no longer is at the moment.  I suspect that this model may no longer be produced.
The artist formerly known as FEG...

Offline dleong

  • Administrator
  • Hero Member
  • *****
  • Posts: 1782
Will Any Other Magazines Fit the CZ 100/101/110
« Reply #3 on: March 05, 2003, 08:37:09 PM »
Quote
Quote:
1. Will the magazines for the 75/85 series pistols fit and function in the CZ 100 series pistols? I have had two answers so far: one "yes" and one "no."

The OEM Mec-Gar magazine supplied with the 40S&W CZ 75B will fit and feed reliably in the 40S&W CZ 100. It extends about an inch beyond the bottom of the grip. However, the slide will not lock back after the last round has been discharged. In comparing the two magazines side-by-side, it can been seen that the mag release notch on the Mec-Gar is positioned a smidge higher than the one on the CZ 100's mag, causing it to sit a bit lower in the mag well and not engage the slide release.

Just for kicks, I inserted the 10-round OEM mag supplied with the 9mm CZ 75B into the 40S&W CZ 100, and managed to cycle some 9mm snap caps through the pistol. The slide did lock back on an empty mag. I take this to mean that the 9mm 75B's 10-round mag will fit and function reliably in a 9mm CZ 100.

DL

Offline joyrock

  • Posts: 8
Re: Will Any Other Magazines Fit the CZ 100/101/110
« Reply #4 on: September 11, 2008, 03:05:03 PM »
My CZ-75BD 16 round mags will fit and work in my CZ-100. BUT, the 10 round mags that came with the CZ-100 will NOT fit in the CZ-75BD, there too short. The 75's mag stick out about 19mm out the bottom of the 100! The CZ-100 also fires and loads Rem 115gr 9MM JHP (the green and white box) fine, but the 75BD jams about every 2-3 rounds. I have order a 26 round mag from CZ-USA, I want to see if it will fit my 100, now that would be cool!
CZ-75BD 9MM
Mosin Nagant M44 7.62X54R
Snakecharmer II 410 Shotgun
CZ-100 9MM
Bryco Arms Model-25 25Cal!

Offline joyrock

  • Posts: 8
Re: Will Any Other Magazines Fit the CZ 100/101/110
« Reply #5 on: September 25, 2008, 08:43:19 AM »
Update: I got my 26 round mag in, and it fits the 100 fine. It sticks out 3 inches, but oh well, and I can see the 20 round hole, that tells me I have shot 6 or more rounds. Oh ya, it also fits my 75BD as well.
CZ-75BD 9MM
Mosin Nagant M44 7.62X54R
Snakecharmer II 410 Shotgun
CZ-100 9MM
Bryco Arms Model-25 25Cal!

Offline soyti

  • Posts: 11
Re: Will Any Other Magazines Fit the CZ 100/101/110
« Reply #6 on: November 07, 2008, 08:30:09 PM »
Just purchased a MECGAR mag for my cz110 9mm. the code of the mag is MGGT2116BDO fits jericho/tangfolio. it is a 15rd mag. it sticks out some .5 inches from the butt. But feeds and locks the slide on the last rounds. have tested it with 100rds without any problems.

Walt Sherrill

  • Guest
Re: Will Any Other Magazines Fit the CZ 100/101/110
« Reply #7 on: November 09, 2008, 08:43:26 AM »
I wonder if they've changed the CZ-100 a bit, over the years.  The one I had, several years ago, would NOT accept or function with standard CZ mags.  It's good to hear that has changed.

I think others here have had OK results with the Pro-Mag CZ100 mags.