Author Topic: New tool came in today  (Read 1927 times)

0 Members and 1 Guest are viewing this topic.

Offline M1A4ME

  • Hero Member
  • *****
  • Posts: 3342
  • I've shot the rest, I now own the best - CZ
Re: New tool came in today
« Reply #15 on: March 20, 2017, 08:21:07 AM »
I see people making negative comments about it on other forums.

People who haven't even used it.  They make negative comments based on  the name of the manufacturer and conclude it's worthless junk.

I'm still smiling about mine.  It's worked great every time I've used it.
Better to have it and not need it, than to need it and not have it.  So, if you see me walking the dogs with my SIG 556R, its okay.

Offline silentbob

  • Jr. Member
  • **
  • Posts: 83
Re: New tool came in today
« Reply #16 on: March 26, 2017, 11:38:37 PM »
I've used mine on three different firearms.  It works pretty well for the rear sight, but can pose a problem with front sights.  Depending on the firearm it might not have enough height to push against the sight, i.e the slide ends up in the pusher.  This happened on an M&P.  Also, if you have a front sight that is installed/removed parallel to the bore this tool won't work on it, i.e Tristar T100.

I am on the look out for a used/inexpensive two ton arbor press, most have 8"-10" of vertical space which will work on those firearms with that type of sight.  It can be used to press anything else, from pins to sights.

Online Luvdog

  • Full Member
  • ***
  • Posts: 144
Re: New tool came in today
« Reply #17 on: March 27, 2017, 10:12:21 AM »
I have the same tool.  I haven't used it yet in any CZ but it's worked fine for the glock sights I've removed

Sent from my iPhone using Tapatalk