Author Topic: Anybody has a video or some decent instructions to install the CGW 10x bushing?  (Read 2211 times)

0 Members and 1 Guest are viewing this topic.

Offline Mr HH

  • Full Member
  • ***
  • Posts: 220
Often if you get a tight bushin to barrel fit it just takes some jiggling. Try turning the barrel just a little and jiggle it while applying just a tiny bit of pressure. It my surprise you and drop right in when you find the sweet spot. I have one like that. It does no good to use force. You just have to find that spot and it will drop in when you would have never thought so.

Offline greystonedog

  • Full Member
  • ***
  • Posts: 108
talked to Scott at CGW, he told me what to do and barrel is installed

Offline zormpas

  • Jr. Member
  • **
  • Posts: 96
  • Zorba, "The Veiled Male"
    • Zorba, "The Veiled Male"
Bushing installed, that was easy, now what do you do when you cant install the barrel,  when barrel is on the angle bushing fit too tight. One post mentioned tapping the recoil lug with a delrin hammer. Think I'll call CGW tomorrow

Mine was like this the very first time - a VERY light tap popped it in, and no problems thereafter. I guess it broke in after the 1st range session as it now goes in without any problems although some jiggling is usually required.

Offline JBLee

  • Newbie
  • *
  • Posts: 25
I tapped the recoil lug with an 8 oz Soft Face Hammer. It worked great. It's a Czech gun, some smacking required!

http://www.homedepot.com/p/8-oz-Soft-Face-Hammer-57-594/203787007
« Last Edit: March 15, 2017, 10:36:51 AM by JBLee »
No matter where you go..there you are - Buckaroo Banzai

Offline tothemax

  • Newbie
  • *
  • Posts: 27
How did you get this issue resolved? 

Offline SlvrDragon50

  • Hero Member
  • *****
  • Posts: 1397
Call Scott if you need help, but it's really quite easy.

Offline Nick B

  • Jr. Member
  • **
  • Posts: 68
How hard is it to get the retaining pin to line up ?

Offline SlvrDragon50

  • Hero Member
  • *****
  • Posts: 1397
How hard is it to get the retaining pin to line up ?

Pretty easy, just align it as best as you can from the start.

Offline Nick B

  • Jr. Member
  • **
  • Posts: 68
How hard is it to get the retaining pin to line up ?

Pretty easy, just align it as best as you can from the start.
So if it doesn't line up do you just tap the bushing back out and start again ?

Offline SlvrDragon50

  • Hero Member
  • *****
  • Posts: 1397
How hard is it to get the retaining pin to line up ?

Pretty easy, just align it as best as you can from the start.
So if it doesn't line up do you just tap the bushing back out and start again ?
Assuming you don't have to file the bushing yes, but it's really quite hard to mess up.


Sent from my iPhone using Tapatalk

 

anything