Author Topic: Magpul Magazine Pull 9mm  (Read 302 times)

0 Members and 1 Guest are viewing this topic.

Offline ecormney

  • Newbie
  • *
  • Posts: 4
Magpul Magazine Pull 9mm
« on: March 20, 2017, 04:44:43 PM »
Anyone try one of these on your scorpion mags? I like them for the ar to cushion drops on concrete but didn't know if they would fit our mags.

Sent from my SM-N920V using Tapatalk


Offline Sigma05

  • Jr. Member
  • **
  • Posts: 72
Re: Magpul Magazine Pull 9mm
« Reply #1 on: March 20, 2017, 04:54:31 PM »


I run them all the time. Make sure you mount them low enough to clear end cap so you can remove it.

Online akuser47

  • Hero Member
  • *****
  • Posts: 573
Re: Magpul Magazine Pull 9mm
« Reply #2 on: March 20, 2017, 07:33:20 PM »
Awesome, I always make paracord ranger loops on my ar mags. I tried to make something cheap for these scorpion mags, and I was unable. I would rather have ranger plates, but these are cheap enough I may use them.
« Last Edit: March 20, 2017, 07:35:26 PM by akuser47 »

Offline ecormney

  • Newbie
  • *
  • Posts: 4
Re: Magpul Magazine Pull 9mm
« Reply #3 on: March 20, 2017, 09:18:32 PM »
Thanks for the feedback. Worried they may not fit on the base pads.

Sent from my SM-N920V using Tapatalk


Offline ecormney

  • Newbie
  • *
  • Posts: 4
Re: Magpul Magazine Pull 9mm
« Reply #4 on: March 20, 2017, 09:20:45 PM »
Sigma05- How did you attach your qd to the loop. Looks good in infde

Sent from my SM-N920V using Tapatalk


Offline Sigma05

  • Jr. Member
  • **
  • Posts: 72
Re: Magpul Magazine Pull 9mm
« Reply #5 on: March 20, 2017, 10:17:35 PM »
Sigma05- How did you attach your qd to the loop. Looks good in infde


https://www.yetiwurks.com/products/denali-qd-point

Offline ecormney

  • Newbie
  • *
  • Posts: 4
Re: Magpul Magazine Pull 9mm
« Reply #6 on: March 21, 2017, 10:39:41 AM »
Thx

Sent from my SM-N920V using Tapatalk


 

anything