Author Topic: New TriStar/Canik Products Coming  (Read 2114 times)

0 Members and 1 Guest are viewing this topic.

Offline CZATC

  • Newbie
  • *
  • Posts: 20
Re: New TriStar/Canik Products Coming
« Reply #30 on: May 19, 2017, 07:06:38 PM »
Do any of the existing spring upgrades fit the Tristar models? You have a whole kit listed on the website in the Tristar section; but when I inquired about it I was told it doesn't work.
SPGK1 3 piece spring kit  blue 13# works beautifully in my c100 and I also put a heavier recoil spring from CZ ordered through midway (20 lb because I saw a lot of guys say that the CZ compacts were under sprung and the canik wound wire looked rough at the ends were clipped and was gouging the cerakote in the recoil guide rod hole) only issue was the slide outran an SP01 18 round mag that is 5 years old and has been kept loaded for probably 2 or 3 of those. New mag spring and 100%. I'm sure schmeky's reduced spring would work well for target loads.

Sent from my Lenovo TAB 2 A10-70F using Tapatalk

CZ 75 SP01-bone stock....CGW bushing and 85 trigger in parts box waiting
TriStar C100 Tungsten Cerakote-CGW kit upon reintroduction :)

Offline schmeky

  • Moderator
  • Hero Member
  • *****
  • Posts: 2475
Re: New TriStar/Canik Products Coming
« Reply #31 on: May 20, 2017, 03:39:18 PM »
The 30100 Canik-TriStar hammer kits are now in stock. 

We have also added the 39350 straight alum single action only triggers for converting your Canik-TriStar to single action only.

Offline gtaylor07

  • Newbie
  • *
  • Posts: 1
Re: New TriStar/Canik Products Coming
« Reply #32 on: May 20, 2017, 09:51:08 PM »
 Will the regular cz sear spacer work for removing the firing pin block as well?

Sent from my Moto G (4) using Tapatalk


Offline schmeky

  • Moderator
  • Hero Member
  • *****
  • Posts: 2475
Re: New TriStar/Canik Products Coming
« Reply #33 on: May 21, 2017, 01:27:02 PM »
gtaylor07,

Yes sir, it will.

Offline CZATC

  • Newbie
  • *
  • Posts: 20
Re: New TriStar/Canik Products Coming
« Reply #34 on: May 25, 2017, 09:35:01 PM »
Just got my hammer kit and floating trigger pin for the c100....Only thing is we close on a house this weekend so no gunsmithing for me for a minute. Ordered Saturday got it Wednesday super excited. Do you think the compact aluminum grips you guys are working on will work with minimal fitting?

Sent from my Lenovo TAB 2 A10-70F using Tapatalk

CZ 75 SP01-bone stock....CGW bushing and 85 trigger in parts box waiting
TriStar C100 Tungsten Cerakote-CGW kit upon reintroduction :)

 

anything