Let me preface this by saying the current full DA pull doesn't really bother me. I've carried revolvers off and on for years, so the initial first pull isn't an issue. But I've wondered.. Could it be better.
So I've been considering replacing the hammer spring for a lighter one, but then found out that replacing the firing pin spring might also be need to be replaced to make sure everything stays reliable. I've found the GCW Ultra-Lite Kit. I like to doing a bit of research on the installation process to be sure it's something I can handle, but cannot find any video's detailing the process.
Would it be the same process on a Safety as on a Decocker?
Thanks Guys!