Author Topic: VZ2008 Brass  (Read 391 times)

0 Members and 1 Guest are viewing this topic.

Offline amg11

  • Newbie
  • *
  • Posts: 2
VZ2008 Brass
« on: May 17, 2017, 04:05:01 PM »
Hi, New here and searched for the topic with limited results.  I recently purchased a previously owned VZ2008 and the first day on the range it had difficulty extracting brass.  Id say about every 5-10 rounds there would be a failure to extract, with the casing pulled halfway out of the chamber while another round was trying jamming the action trying to feed.  I did shoot one full mag with no problems but the final mag after that it started back up again along with a couple of stove pipes.  The ammo was Red Army Elite, if that means anything.  Anyone else had this problem and fixed it?

Offline RSR

  • Hero Member
  • *****
  • Posts: 3128
Re: VZ2008 Brass
« Reply #1 on: May 17, 2017, 04:49:53 PM »
Pics of cases?

This is probably your issue: http://www.czfirearms.us/index.php?topic=78148.0

Offline amg11

  • Newbie
  • *
  • Posts: 2
Re: VZ2008 Brass
« Reply #2 on: May 17, 2017, 05:34:29 PM »
I will take some next time I make it to the range.  I looked at the above link, he only time I have failure to feed is when the previous casing failed to extract

 

anything