Author Topic: Staking hammer pins on cz custom hammer  (Read 390 times)

0 Members and 1 Guest are viewing this topic.

Offline Morbid1X

  • Full Member
  • ***
  • Posts: 145
Staking hammer pins on cz custom hammer
« on: October 15, 2017, 11:54:20 PM »
I have a p01 that is giving me little fits and it's really working on my ocd. So I put a cz custom hammer in my p01, What is best way to go about making sure those pins stay in place. What's happening is the disconnecter pin is sliding from side to side and causing my trigger and hammer to lock up. Tried initially with the cgw hpins they were way loose then I used the original oem pins and they still seem to slip a bit. How should I go about getting  those sucker to stay in place. I'm tired fellas, of taking my p01 apart :'(..... I'm a master at the decocker sear cage assembly now from taking it apart so many times trying different things, those hammer pins haven't been the only thing I was unhappy with,  but that's a story for another day. Any suggestions?

Offline Earl Keese

  • Hero Member
  • *****
  • Posts: 1723
Re: Staking hammer pins on cz custom hammer
« Reply #1 on: October 16, 2017, 06:29:10 AM »
Lay the hammer & strut on a hard flat surface. Place a center punch in the original staking location and whack 'em again.

Offline jaybee1018

  • Newbie
  • *
  • Posts: 2
Re: Staking hammer pins on cz custom hammer
« Reply #2 on: October 26, 2017, 08:57:14 PM »
Using an oem or soft pin put the punch on the edge, pin side and whack it good.
But if u r using the cgw hard pin put the punch on the edge, hammer side. Whack it good too. Lol.
     This is what i did on my cz sp 01 shadow using cgw hard pin.
        File any burrs when done stacking. Hope this helps.

Offline Morbid1X

  • Full Member
  • ***
  • Posts: 145
Re: Staking hammer pins on cz custom hammer
« Reply #3 on: October 30, 2017, 07:12:06 PM »
I was able to stake the oem pins