Author Topic: Red Dot Optic Slide Milling  (Read 142 times)

0 Members and 1 Guest are viewing this topic.

Offline MissionaryMike

  • Full Member
  • ***
  • Posts: 177
Red Dot Optic Slide Milling
« on: December 05, 2017, 10:00:39 AM »
Taking suggestions on who to send my P-10 C slide to for red dot sight milling.  I know about CGW and CZC already.  Just checking to see what else is out there in the market, and what the CZ community here has to say about them.

Thanks!
"We think the 'X' is a sweet pistol, but like most CZ's, there is going to be some fine tuning to Americanize it."  -Schmeky a.k.a. CGW a.k.a. David

CZ Shadow 2 (9mm)(Cajun Seasoning)
CZ P-09 FDE (9mm)(Cajunized) (FOR SALE)
CZ P-10 C FDE (9mm)(...)

Offline M1A4ME

  • Hero Member
  • *****
  • Posts: 2717
  • I've shot the rest, I now own the best - CZ
Re: Red Dot Optic Slide Milling
« Reply #1 on: December 05, 2017, 01:37:36 PM »
I sent the P07 and P09 Primary Machine.  Had the slides milled, the slides cerakoted and the slides milled for a rear sight.  They also installed the sights.  No issues with either of them.

After almost 2 years the P07 slide is starting to wear through the cerakote where it rubs the kydex holster going in/out once or twice a day.
Better to have it and not need it, than to need it and not have it.  So, if you see me walking the dogs with my SIG 556R, its okay.

Offline jetcycles

  • Newbie
  • *
  • Posts: 23
Re: Red Dot Optic Slide Milling
« Reply #2 on: December 07, 2017, 09:28:52 AM »
Primary Machine milled my P07 slide.  Excellent communication, excellent work, and excellent turnaround time.

Offline HST

  • Jr. Member
  • **
  • Posts: 86
Re: Red Dot Optic Slide Milling
« Reply #3 on: December 08, 2017, 08:45:38 AM »
Sending in my P 10 to primary Machine today  ;D

 

anything