Author Topic: Stronger Spring for RAMI 9mm 14-rd Magazine  (Read 163 times)

0 Members and 1 Guest are viewing this topic.

Offline Geobob

  • Newbie
  • *
  • Posts: 24
  • dum spiro spero
Stronger Spring for RAMI 9mm 14-rd Magazine
« on: June 13, 2018, 02:35:17 PM »
Good Wednesday, All

Any suggestions as to where to get a stronger spring for the RAMI 9mm 14-rd magazine?  I checked with Wolff Springs and they don't carry them (working on it, but not yet).  I need a stronger than factory spring for the extended mag to help with cartridge feed when using a suppressor; the added weight affects the barrel/chamber ramp movement during firing cycling and causes fail-to-load (bullet head hits bottom of ramp). The smaller 10-rd mag feeds perfectly fine (probably a stronger spring action).

Thanks!
Geologist Bob
US Navy P-3 Pilot, US Army Guard Huey & Blackhawk Pilot (ret.)

Online MeatAxe

  • Sr. Member
  • ****
  • Posts: 562
Re: Stronger Spring for RAMI 9mm 14-rd Magazine
« Reply #1 on: June 13, 2018, 07:52:22 PM »
CZ Custom has both +5% and +10% mag springs.

Offline Esquilax

  • Jr. Member
  • **
  • Posts: 26
Re: Stronger Spring for RAMI 9mm 14-rd Magazine
« Reply #2 on: June 13, 2018, 10:58:01 PM »
See the current "failure to feed" thread, e.g. post #103.

But woah woah woah... Missing the important bits. Is the threaded barrel a custom job or what?

Offline Geobob

  • Newbie
  • *
  • Posts: 24
  • dum spiro spero
Re: Stronger Spring for RAMI 9mm 14-rd Magazine
« Reply #3 on: June 14, 2018, 02:18:54 PM »
Thanks, MeatAxe and Esquilax for your info.

Yes, the threaded barrel was s custom job - done by Tornado Technologies:
https://www.tornado-technologies.com/

I sent in my RAMI barrel and they added a threaded extension - did a marvelous job.  I posted the results/pics sometime last year when I got the barrel back. Just got the surpressor (7 months waiting).

Thanks again
Geologist Bob
US Navy P-3 Pilot, US Army Guard Huey & Blackhawk Pilot (ret.)